Arming the alarm using the
remote control
Switch off the ignition and leave the
vehicle.
Ensure that all doors and the boot
are closed.
Lock the vehicle using button A on
the remote control.
When the alarm is armed, the
protections become active within
5 seconds (perimeter) and
45 seconds (volumetric).
Your vehicle may be equipped with
an anti-intrusion alarm.
This ensures:
• Exterior perimeter protection by
means of detectors on the access
points (doors, tailgate, bonnet) as
well as on the electrical supply.
• Interior volumetric protection
by means of ultrasonic sensors
(detecting movement inside the
passenger compartment).
This can be deactivated using
control 1.
The installation also includes a siren
and a warning lamp 2 visible from
the outside, indicating the three
possible alarm statuses:
• Alarm not armed (not on standby),
warning lamp off.
• Alarm armed (on standby), the
warning lamp ashes slowly.
• Alarm triggered (signalling an
intrusion), the warning lamp ashes
rapidly if the alarm is disarmed
with a press on button B. It stops
ashing as soon as you switch on
the ignition.
Note: in the event of a malfunction,
the warning lamp 2 comes on con-
tinuously.
ANTI-INTRUSION ALARM
Triggering
Provided the alarm is armed,
any intrusion triggers the siren
for 30 seconds, accompanied by
the illumination of the direction
indicators.
The alarm then reverts to armed
status, but the deployment remains
memorised and is signalled by the
rapid ashing of the alarm warning
lamp 2 when you press the unlocking
button B. The ashing stops when
you switch on the ignition.
The siren is also triggered if there is
a cutting of the electrical supply. To
stop it, restore the electrical supply
then give a press on the unlocking
button B.
Comentarios a estos manuales